top of page

INIC-1430

The Initio INIC-1430 provides an advanced solution to connect ATAPI or EIDE devices to IEEE-1394a interface with integrated CPU and embedded SRAM. To provide high performance and cost effective solution, the inic-1430 integrates 1394a link core, ATA control block and microprocessor into a single ASIC. The inic-1430 provides the data transfer rate of up to 50 MB/sec, its ATA interface supports ultra DMA modes (33/66/100 MB/sec).

Features Summary

  • IEEE Std 1394-1995 and 1394a Compliant

  • Support industry standard PHY

  • Support Asynchronous Transfers at 100, 200 and 400 Mb/s

  • Perform 1394a Cycle Master

  • Implement SBP-2 stack to optimize the performance

  • T13 1410D ATA/ATAPI-6 Compliant

  • Support DMA mode 0-2, and UDMA mode 2, 4 and 5 (up to 100MB/s)

  • Integrated internal CPU with embedded SRAM

  • Implement the firmware download mechanism

  • Local Bus Interface to serial NVRAM and Flash memory

  • Up to 17 GPIO pins

  • Low power CMOS with 3.3Volts

  • 128-pin LQFP package

​Firmware/Software Support

  • Protocols support including SBP-2, MMC-2, RBC and ATA/ATAPI

  • Provide software utilities for downloading the upgraded firmware code

​Device Support

  • Hard disk drives

  • CD-RW devices

  • DVDs

  • Removable media devices

​INIC-1430 Datasheet

  • Product Brief

  • Requesting a Datasheet

bottom of page