top of page

INIC-1605

The Initio INIC-1605 provides an advanced solution to connect SATA devices to USB Host with integrated CPU and embedded SRAM. To provide high performance and cost effective solution, INIC-1605 integrates USB-PHY Mass Storage Class Bulk-Only USB function, SATA link/PHY core and microprocessor into a single ASIC. INIC-1605 provides the data transfer rate of up to 60 MB/sec connecting to a SATA interface.

Features Summary

  • Integrates USB2.0 PHY IP core.

  • Data transfer rate of up to 60 MB/sec on USB side, 150 MB/sec on SATA side.

  • Integrated internal Turbo 8051 up with 16KB embedded SRAM.

  • Program Flash In-Line (Firmware download mechanism, USB direct for MFG Test, write .bta file.

  • Local Bus Interface to Serial Peripheral Interface (SPI) Flash Only.

  • Support HID.

  • Up to 9 GPIO pins.

  • Use a single crystal for both USB and SATA.

  • Provide software utilities for downloading the upgraded firmware code under USB.

  • Supports SATA (bridged SATA) Hard Disk drives, CD-RW devices, DVDs, Removable media devices, BD (Blu-Ray Disc) drive

  • USB 1.1 and USB 2.0 compliant.

  • USB Mass Storage Class Bulk-Only Transport Specification Compliant.

  • Serial ATA Revision 2.5 specification Compliant (Hot Plug is supported).

  • Supports 3Gbps SATA HDD connection.

  • Support ATA/ATAPI device DMA and PIO mode.

  • 4k bytes of data buffer for data transfer.

  • On-Chip 3.3V to 1.8V regulator

  • 64 pin LQFP (7mm x 7mm or 10mm x 10mm)

​Firmware/Software Support

  • USB Mass Storage Class Bulk-Only Transport support

  • Provide software utilities for downloading the upgraded firmware code

​Device Support

  • Hard disk drives

  • CD-RW devices

  • DVDs

  • Removable media devices

  • Blu-Ray Disk driver

​INIC-1605 Datasheet

  • Product Brief

  • Requesting a Datasheet

bottom of page