INIC-1606
The Initio INIC-1606 provides an advanced solution to connect SATA devices to USB Host with integrated CPU and embedded SRAM/ROM. To provide high performance and cost effective solution, the INIC-1606 integrates USB-PHY Mass Storage Class Bulk-Only USB function, SATA link/PHY core and microprocessor into a single ASIC. The INIC-1606 provides the data transfer rate of up to 60 MB/sec connecting to a 1.5G SATA interface.
Features Summary
-
Integrates USB2.0 PHY IP core.
-
Data transfer rate of up to 60 MB/sec.
-
Integrated internal Turbo 8051 uP with 24KB embedded ROM and 2KB SRAM.
-
External NVRAM supported (optional).
-
Support HID.
-
Up to 9 GPIO pins.
-
Use a single crystal for both USB and SATA.
-
Supports SATA (bridged SATA) Hard Disk drives, CD-RW devices, DVDs, Removable media devices, BD (Blu-Ray Disc) drive
-
USB 1.1 and USB 2.0 compliant.
-
USB Mass Storage Class Bulk-Only Transport Specification Compliant.
-
Serial ATA Revision 2.5 specification Compliant.
-
Support ATA/ATAPI device DMA and PIO mode.
-
2k bytes of data buffer for data transfer.
-
On-Chip 3.3V to 1.8V regulator.
-
64 pin LQFP, 7x7mm or 10x10mm
Firmware/Software Support
-
USB Mass Storage Class Bulk-Only Transport support
-
Provide software utilities for NVRAM upgraded.
Device Support
-
Hard disk drives
-
CD-RW devices
-
DVDs
-
Removable media devices
-
Blu-Ray Disk driver
INIC1606 Datasheet
-
Product Brief
-
Requesting a Datasheet