top of page

INIC-1611

The Initio INIC-1611 provides an advanced solution to connect SATA devices to USB or SATA Host with integrated CPU and embedded SRAM/ROM. To provide high performance and cost effective solution, the INIC-1611 integrates USB-PHY Mass Storage Class Bulk-Only USB function, SATA link/PHY core and microprocessor into a single ASIC. The INIC-1611 provides the data transfer rate of up to 60 MB/sec connecting to a 1.5G SATA interface.

Features Summary

  • Integrates USB2.0 PHY IP core.

  • Data transfer rate of up to 60 MB/sec on USB side, 150 MB/sec on SATA side.

  • Integrated internal Turbo 8051 uP with 24KB embedded ROM and 2KB SRAM.

  • External NVRAM supported.

  • Support HID.

  • Up to 9 GPIO pins.

  • Use a single crystal for both USB and SATA.

  • Supports SATA (bridged SATA) Hard Disk drives, CD-RW devices, DVDs, Removable media devices, BD (Blu-Ray Disc) drive

  • USB 1.1 and USB 2.0 compliant.

  • USB Mass Storage Class Bulk-Only Transport Specification Compliant.

  • Serial ATA Revision 2.5 specification Compliant. (Hot Plug is supported).

  • Support SATA to SATA pass through.

  • Supports SATA NCQ.

  • Supports 3Gbps SATA host and 3Gbps SATA HDD

  • Support ATA/ATAPI device DMA and PIO mode.

  • 2k bytes of data buffer for data transfer.

  • On-Chip 3.3V to 1.8V regulator.

  • 64 pin LQFP

​Firmware/Software Support

  • USB Mass Storage Class Bulk-Only Transport support
    Provide software utilities for NVRAM upgraded.

​Device Support

  • Hard disk drives
    CD-RW devices
    DVDs
    Removable media devices
    Blu-Ray Disk driver

​INIC1611 Datasheet

  • Product Brief

  • Requesting a Datasheet

bottom of page